1) The wiring outside the tray should be protected by appropriate methods, such as hose and steel pipe. And wiring should go to the machine tool is not easy to damage the place.
2) The wire or power cord between the machine tools outside the disk must be put into the bridge. The bridge is supported by the base and does not touch the ground!
3) The pipe outside the plate should be unified.
4) For the connection of heating equipment such as packaging machine, wiring should not be located near the heating part. Wiring is carried out in the connecting box with terminal platform. The heater is connected with glass or ceramic pipe wires, not flammable wires.
5) All wire connections outside the plate should be carried out in the connecting box, and there can be no joint in the middle of the line.
6) The protection level of all connection boxes (relay boxes) outside the tray and the inlet part of the wire must be above IP55.
7) The same terminal of the relay terminal platform is connected with at most two wires. If more than 3 wires are connected, please set other terminal platforms.
8) If the wiring of the inductor is carried out in the part that is easy to be hit, a hose should be used for protection, and the hose should be set at the root of the inductor as far as possible.
